- 品牌:清阳
- 型号:SOLAR48-20A
solar48型系列控制器(不防水)
使用说明书
solar48型太阳能充放电控制器系我公司自主开发的最新专利产品,适合2500w以下太阳能发电系统的自动控制。
功能:
1.过载保护
2.短路保护
3.雷电保护
4欠压保护
5.过充保护
ii 接线:
1.将蓄电池的“+”、“-”极正确牢固地连接到控制器相应的端子上(左起第3、第4)。
*负荷指示灯(左起第一个绿灯)闪动一下并且15秒后会亮起,表示连接正确,可继续进行下列连接。否则会损坏控制器。
2.将太阳能板的“+”、“-”极正确牢固地连接到控制器相应的端子上(左起第1、第2)。
*如果连接错误会损坏你的控制器。
3.将负载的“+”、“-”极正确牢固地连接到控制器相应的端子上(左起第5、第6)
iii 指示灯:
1.充电指示灯(左起第一个绿灯),亮起表示正在强力充电,闪动表示正在浮动充电,不亮表示充电已经停止。
2.负荷指示灯(左起第二个绿灯),亮起表示有输出,负载可以工作;不亮表示没有输出,负载不能工作。
注意事项:
1.接线前请仔细核对并确认太阳能板、蓄电池、负载的额定电压,三者的额定电压应相同,且都是48v。
2.太阳能板、负载的额定电流不得大于控制器的额定电流。
附 参数表:
型号:
solar48
显示
直观led
额定电压
12v/24v
供电停止电压
10.8v/21.6v
额定充电电流
20a/30a/40a/50a
供电恢复电压
11.8v/23.6v
额定负载电流
20a/30a/40a/50a
充电停止电压
14v/27.2v
工作温度
-20 ~ +60℃
停充电压温度系数
-3mv/℃/cell
尺寸
(l*w*h)185*165*80mm
净重
0.6kg
*参数可根据用户要求定制。
solar charge controller (non waterproof)
user’s manual
the product can automatically manage the work of solar panel and battery in solar system, which is below 2500w.
i. function:
1. over-load protection 2. short-circuit protection
3. lightning protection 4. reverse discharging protection
5. reverse-polarity protection 6. under-voltage protection
7. over-charging protection
ii. connection (as indicated in diagram)
open the top cover of controller, connect the wire and terminals of controller according to the drawing on the top cover of controller.
1. connect the “+”, “-“ poles of the battery to the correct ports of controller (3 th & 4th one from left)
*if load indicator (“load”) flickers once and starts lighting after 15 seconds, you can tell the connection is correct; the following operation can be proceed, otherwise, the following operation may damage the controller.
2. connect the “+”, “-” poles of the solar panel to the correct ports of controller (1st & 2th one from left)
*incorrect connection may damage controller.
3. connect the “+”, “-” poles of the load to the correct ports of controller (5th & 6th from left)
iii idicator led
1. the battery is being charged strongly when the charge led is lighting, flickering means the battery is in floating charge mode, if it’s off means charging stopped.
2. when the load led is lighting, it means there is a output and load can work; if it’s off, there isn’t output and the load cannot work.
notices:
1. please make sure the rated voltage of solar panels, batteries the loads are same and are all 48v.
2. the rated current of solar panels and load must be less than the rated current of controller.
specifications:
型号:
solar48
显示
直观led
额定电压
12v/24v
供电停止电压
10.8v/21.6v
额定充电电流
20a/30a/40a/50a
供电恢复电压
11.8v/23.6v
额定负载电流
20a/30a/40a/50a
充电停止电压
14v/27.2v
工作温度
-20 ~ +60℃
停充电压温度系数
-3mv/℃/cell
尺寸
(l*w*h)185*165*80mm
净重
0.6kg
*parameters can be customized by customers.
深圳市清阳新能源技术有限公司
kingsun technology co., ltd, shenzhen
深圳市清阳新能源技术有限公司
吴勇
13316435300
西乡新安六路径贝村同富楼A1-3F